
Repairs
Repair & Maintenance
A door can be brought back from a surprising amount. Crooked in the opening, scraping the jamb, missing a roller or two: with the right hardware on the van, most of these are resolved in a single visit.



Which one do I need?
- Your toddler has discovered the wall button.Garage Door Safety Inspection
- Every morning the door announces itself to the whole street: a long metallic squeal as it climbs, a rattle at the top, and a groan on the way back down.Garage Door Tune-Up
- Your car is inside and the door is stuck crooked across the opening.Off-Track Garage Door Reset
- The top section has developed a bend where the opener arm pulls on it.Garage Door Panel Replacement
- The gap under the door is a finger wide at one end and nothing at the other.Garage Door Bottom Seal Replacement
- With the door closed and the garage lights off, a thin bright line runs down the whole left side of the opening.Garage Door Perimeter Weatherstrip
Repair & Maintenance
Inspection, adjustment, sealing, and section-level repairs.







Garage Door Safety Inspection
Springs, cables and drums, looked at and left alone
The counterbalance gets a careful look and nothing more during the inspection. On a torsion door the technician checks the spring coil for a gap, rust or a stretched section, confirms the cone set screws and centre bearing look sound, and follows each cable from the drum to the bottom bracket looking for broken wires, a rust bloom near the loop or a slack side. The drum wrap is checked for a single neat layer.
On an extension door the springs, pulleys and containment cables are examined the same way. Any adjustment to these parts is a separate, planned job matched to that system, torsion tension controlled with winding bars rather than simply released; the inspection records their condition.
